Indy created and released the first Kneeboard racks, combo wake/kneeboard on the aftermarket.
ANODIZED superior finish.
The main difference is the location of the kneeboard slot. It is on the
bottom of the rack, with the wakeboard slot is on top. This allows you
to have easy access to you kneeboard without dodging and fighting with
your wakeboard and boots.
Having the kneeboard on the bottom, makes slotting the bulky kneeboard
into the rack so much easier that trying to put into a high angled
position above a bulky wakeboard. Plus a bottom position the bungee cord
us up against the base of your board, no compressing and damaging your
padded area of your kneeboard.
This middle finger tip being thick, has the slots angled apart so the
boards, angle away from each other. Therefore, no hitting each other.
That has to be work it in the long run, no damage.
If you look close at the bottom of the slot you will notice it is a
triangular wedge shape for the top position wakeboard, this is on
purpose to give your board that extra bit of locking into place to
reduce movement whilst in the rack and held in place by the bungee cord
strap. A closer look at the bottom slot you will notice a couple of
curves, this is created to take a normal thick surfboard as well as
locking in the molded edge of the thick kneeboards and room for the foam
padding. Being on the bottom also protects the foam on top of your
kneeboard from the bungee strap. Other brands the bungee comes down
tight onto your padding and over time damages it.
The finger attach from the side for a reason, if you look close there
are 3 separate holes, you can adjust the fingers angle by changing which
hole you place the bolt to attach. So once you have attached the rack
to your tower legs (as we know all rear legs will be different on
different boats) you can now personally adjust to the angle you want
your kneeboard and wakeboard to sit.
We have then came up with a solution for those who do not want to spend the extra cash on a swing rack adaptor for simple storage whilst driving or parking in the dock to get your racks inside the boats outline.
In the design is an extra hole you can see up the top finger. This
allows you to undo and bolt and swing the finger down and inside the
boats outline and re attach the bolt. Keeping the rack on the tower for
travel and storage in a dock, without the risk of knocking of the
fingers on a vehicle, building or trees.
Clamps are 2.5inch with a 2.25inch rubber insert.
We use quality raw material a 6061 solid Aircraft Aluminium which is
cnc machined to our specs in thickness and design for pure performance.
The inside surface of the finger has a special machined 4mm channel to
take our UV treated hard rubber bumper which is a mushroom shape to look
after your boards. All the hardware is stainless steel for the marine
environment. We include a marine grade bungee cord which is already
installed for your use.
The difference is the finer details